Toro 22303 Dingo 320-D - Charging and Connecting the Battery; Checking Fluid Levels

Step
2
Charging and Connecting
the Battery
No Parts Required
Procedure
Batter y ter minals or metal tools could shor t
a gainst metal components, causing spar ks.
Spar ks can cause the batter y gasses to
explode, r esulting in per sonal injur y .
• W hen r emo ving or installing the batter y ,
do not allo w the batter y ter minals to
touch an y metal par ts of the traction unit.
• Do not allo w metal tools to shor t betw een
the batter y ter minals and metal par ts of
the traction unit.
1. R emo v e the 4 bolts securing the batter y co v er
and remo v e it from o v er the batter y .
2. R emo v e and discard the plastic cap from the
neg ati v e batter y ter minal.
3. Connect a c harg er to the batter y ( Figure 4 ) and
c harg e it for a minim um of 1 hour at 6 to 10
amps . Do not o v erc harg e the batter y .
1
2
3
4
G003792
Figure 4
1. Positive post
3. Charger red (+) wire
2. Negative post
4. Charger black (—) wire
Charging the batter y pr oduces gasses
that can explode.
Nev er smok e near the batter y and k eep
spar ks and flames a w ay fr om batter y .
4. W hen the batter y is fully c harg ed, unplug
the c harg er from the electrical outlet, then
disconnect the c harg er leads from the batter y
posts ( Figure 4 ).
5. Cut the tie securing the loose end of the
neg ati v e batter y cable to the frame . T he cable
is located to the right of the engine and is
routed forw ard and tied to the frame at the
factor y .
6. R oute the neg ati v e batter y cable from the
engine compar tment to the batter y and secure
it to the neg ati v e batter y ter minal.
7. Install the batter y co v er and close the rear
access co v er .
Step
3
Checking Fluid Levels
No Parts Required
Procedure
Before star ting the engine for the first time , c hec k
the engine oil, radiator coolant, and h y draulic fluid
lev els . R efer to Operation for more infor mation.
12