Figure 23
Figure 24
4. Pump g rease into the fittings until g rease begins
to ooze out of the bearings (appro ximately 3
pumps).
5. Wipe up any ex cess g rease .
Engine Maintenance
Servicing the Air Cleaner
Clean the primar y filter ev er y 25 operating hours .
R e place the primar y and secondar y filter yearly .
Note: Ser vice the air cleaner more frequently if
operating conditions are extremely dusty or sandy .
Removing the Filters
1. Lo w er the loader ar ms and stop the engine .
R emo v e the k ey .
2. Open the rear access co v er .
3. R elease the latc hes on the air cleaner and pull
the air cleaner co v er off of the air cleaner body
( Figure 25 ).
Figure 25
1. Latches 4. Primary lter
2. Air cleaner cover 5. Safety lter
3. Air lter body
4. Clean the inside of the air cleaner co v er with
compressed air .
5. Gently slide the primar y filter out of the air
cleaner body ( Figure 25 ). A v oid knoc king the
filter into the side of the body . Do not remo v e
the safety filter , unless y ou intend to re place
it as w ell.
6. Inspect the primar y filter for damag e b y
looking into the filter while shining a bright
light on the outside of the filter . Holes in the
filter will appear as bright spots . If the filter is
damag ed, discard it; otherwise , clean it.
Important: Nev er attempt to clean the
safety filter . If the safety filter is dir ty ,
then the primar y filter is dama ged and y ou
should r eplace both filter s.
Cleaning the Primary Filter
Blo w compressed air from the inside to the outside
of the primar y filter .
Important: Do not ex ceed 100 psi (689 kP a)
and k eep the hose at least 2 inches (5 cm)
fr om the filter .
Installing the Filters
1. If installing new filters , c hec k eac h filter for
shipping damag e . Do not use a damag ed filter .
2. If the safety filter is being re placed, carefully
slide it into the filter body ( Figure 25 ).
27
To Next Page
Loading...
