Note: No w is the best time to install a new
fuel filter because the fuel tank is empty .
7. Install the fuel line onto the fuel filter .
8. Slide the hose clamp close to the fuel filter to
secure the fuel line .
9. Close the rear access co v er .
10. Open the fuel v alv e on the bottom of the fuel
tank.
Electrical System
Maintenance
Servicing the Battery
Important: T he f ollo wing pr ocedur es
appl y when ser vicing a (dr y) batter y that has
r eplaced the original batter y . T he original
(w et) batter y does not r equir e ser vice.
Chec k the electrolyte lev el in the batter y ev er y 100
hours . Alw a ys k ee p the batter y clean and fully
c harg ed. Use a paper to w el to clean the batter y
case . If the batter y ter minals are cor roded, clean
them with a solution of four par ts w ater and one
par t baking soda. Apply a light coating of g rease
to the batter y ter minals to reduce cor rosion.
V oltag e: 12 v , 435 Cold Cranking Amps
Checking the Electrolyte Level
1. Stop the engine and remo v e the k ey .
2. R emo v e the 4 bolts securing the batter y co v er
and remo v e it from o v er the batter y .
3. Look at the side of the batter y . T he electrolyte
m ust be up to the Upper line ( Figure 33 ).
Do not allo w the electrolyte to fall belo w the
Lo w er line ( Figure 33 ).
Figure 33
1. Filler caps 3. Lower line
2. Upper line
4. If the electrolyte is lo w , add the required
amount of distilled w ater; refer to Adding
W ater to the Batter y , belo w .
Adding Water to the Battery
T he best time to add distilled w ater to the batter y
is just before y ou operate the traction unit. T his
lets the w ater mix thoroughly with the electrolyte
solution.
Batter y electr ol yte contains sulfuric acid
which is a deadl y poison and causes sev er e
bur ns.
• Do not drink electr ol yte and a v oid
contact with skin, ey es or clothing . W ear
safety g lasses to shield y our ey es and
r ub ber g lo v es to pr otect y our hands.
• Fill the batter y wher e clean w ater is
al w ays a v aila ble f or flushing the skin.
1. R emo v e the batter y from the traction unit.
Important: Nev er fill the batter y with
distilled w ater while the batter y is installed
in the traction unit. Electr ol yte could be
spilled on other par ts and cause cor r osion.
2. Clean the top of the batter y with a paper to w el.
3. R emo v e the filler caps from the batter y
( Figure 33 ).
4. Slo wly pour distilled w ater into eac h batter y
cell until the electrolyte lev el is up to the Upper
line ( Figure 33 ) on the batter y case .
31
To Next Page
Loading...
