EasyManua.ls Logo

Toro 22303 Dingo 320-D - Servicing the Engine Oil

Toro 22303 Dingo 320-D
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Carefully slide the primar y filter o v er the safety
filter ( Figure 25 ). Ensure that it is fully seated
b y pushing on the outer rim of the filter while
installing it.
Important: Do not pr ess on the soft
inside ar ea of the filter .
4. Install the air cleaner co v er with the side
indicated as UP facing up and secure the
latc hes ( Figure 25 ).
5. Close the rear access co v er .
Servicing the Engine Oil
Chang e oil after the first 50 operating hours and
then ev er y 75 operating hours thereafter .
Note: Chang e oil more frequently when
operating conditions are extremely dusty or sandy .
Oil T ype: Diesel engine oil (API ser vice CD or
higher)
Crankcase Capacity: w/filter , 0.84 g al. (3.2 l)
Figure 26
Changing Oil
1. Star t the engine and let it r un for fiv e min utes .
T his w ar ms the oil so it drains better .
2. P ark the traction unit so that the drain side is
slightly lo w er than the opposite side to ensure
that the oil drains completely .
3. Lo w er the loader ar ms , c hoc k the wheels , and
stop the engine . R emo v e the k ey .
Components will be hot if the traction
unit has been r unning . If y ou touch hot
components y ou may be bur ned.
Allo w the traction unit to cool bef or e
perf or ming maintenance or touching
components under the hood.
4. Place a pan under the oil drain tube ( Figure 27 ).
Figure 27
1. Clamp 3. Plug
2. Oil drain tube
5. Loosen the clamp and remo v e the plug
( Figure 27 ).
6. W hen the oil has drained completely , re place
the plug and tighten the clamp .
Note: Dispose of the used oil at a cer tified
recycling center .
7. Open the rear access co v er .
8. R emo v e the oil fill cap and slo wly pour
appro ximately 80% of the specified amount of
oil in through the v alv e co v er .
9. Chec k the oil lev el; refer to Chec king the Oil
Lev el, in Operation.
10. Slo wly add additional oil to bring the lev el to
the upper mark/hole on the dipstic k.
11. R e place the fill cap .
12. Close the rear access co v er .
Changing the Oil Filter
R e place the oil filter ev er y 150 hours or ev er y
other oil c hang e .
Note: Chang e the oil filter at eac h oil c hang e
when operating conditions are extremely hot,
dusty , or sandy .
28

Related product manuals