Toro 30602 - Drive System Maintenance; Adjusting the Traction Pedal Angle; Changing the Planetary Gear Drive Oil

DriveSystem
Maintenance
AdjustingtheTractionPedal
Angle
Thetractionpedaloperatinganglecanbeadjustedfor
operatorcomfort.
1.Loosenthetwonutsandboltssecuringtheleftsideof
thetractionpedaltothebracket(Figure61).
Figure61
1.Tractionpedal2.Mountingnutsandbolts
(2)
2.Pivotthepedaltothedesiredoperatingangleand
tightenthenuts(Figure61)˙.
ChangingthePlanetaryGear
DriveOil
ServiceInterval:Aftertherst200hours
Every800hours(Oryearly,whichevercomesrst)
Changetheoilinitiallyafterrst200hoursofoperation.
Thereafterchangetheoilevery800hours,oryearly,whichever
occursrst.UseahighqualitySAE85W-140gearlube.
1.Withthemachineonalevelsurface,positionawheel
sothatoneofthecheckplugsisatthelowest(6
o'clock)position(
Figure62).
Figure62
1.Check/drainplug
2.Placeadrainpanundertheplanetaryhub,removeplug
andallowoiltodrain.
3.Placeadrainpanunderthebrakehousing,removethe
drainplugandallowtheoiltodrain(Figure42).
g020680
Figure63
1.Drainplug2.Brakehousing
4.Whenalloftheoilhasdrainedfrombothlocations,
re-installthepluginthebrakehousing.
5.Rotatethewheeluntiltheopenplugholeinthe
planetaryisatthetwelveo'clockposition.
6.Throughtheopenhole,slowlylltheplanetarywith
0.5liter(22ounces)ofhighqualitySAE85W-140wt.
gearlube.
Important:Iftheplanetaryllsbeforethe0.5liter
(22ounces)ofoilisadded,waitonehourorinstall
theplugandmovethemachineapproximatelyten
feettodistributetheoilthroughthebrakesystem.
Then,removetheplugandaddtheremainingoil.
7.Re-installtheplug.
8.Repeattheprocedureontheoppositeplanetary/brake
assembly.
45