Toro 30632 - Adjusting the Handle Height

G012679
Figure17
AdjustingtheHandleHeight
Youcanadjustthehandlepositiontomatchyourheight
preference.
1.Removethehairpincotterpinsandclevispinsfrom
thedriveleversandneutrallocks(Figure18).
g012931
Figure18
1.Controlrod
5.Neutrallock
2.Clevispin
6.Hairpincotterpin
3.OperatorPresence
Controllever(OPC)
7.Drivelever
4.Handle
2.Loosentheupperbolts(3/8x1-1/4inches)andange
nutsecuringhandletorearframe(Figure19).
3.Removethelowerbolts(3/8x1inch)andangenuts
securingthehandletotherearframe(Figure19).
4.Pivotthehandletothedesiredoperatingpositionand
installthelowerangebolts(3/8x1inch)andange
nutsintothemountingholes.
Note:Tightenallangebolts.
Figure19
1.Upperhandle6.Lowermountingholes
2.Rearframe
7.Lowposition
3.Flangebolt(3/8x1inch)
8.Middleposition
4.Locknut(3/8inch)
9.Highposition
5.Uppermountinghole
5.Adjustthecontrolrodlengthbyrotatingthecontrol
rodintherodtting(Figure18).
6.Installahairpincotterbetweenthedriveleversandthe
neutrallocksandintotheclevispins(Figure18).
Note:Makesurethattheclevispinsareinsertedinto
theneutrallocks.
7.Checktheparkingbrakeadjustment.RefertoChecking
theBrakesinBrakeMaintenance(page31).
21