Toro 30632 - Controls System Maintenance; Adjusting the Control Rods

Figure49
1.Bellcrank
3.Switchmountingbracket
2.Boltsandnuts
4.Switchbody
6.Tightentheswitchmountingbracket.
ControlsSystem
Maintenance
AdjustingtheControlRods
1.Removethehairpincotterpinsandclevispinsfrom
thedriveleversandneutrallocks(Figure50).
g012931
Figure50
1.Controlrod
5.Neutrallock
2.Clevispin
6.Hairpincotter
3.Operator-presence-control
lever(OPC)
7.Lefthandleshown
4.Handle8.Drivelever
2.Adjustthecontrolrodlengthbythreadingtherodinor
outoftherodttinguntilthereisa5to6mm(3/16to
1/4inches)clearancebetweenthecontrolrodandthe
bottomoftheneutral/parkingbrakelock(Figure51).
Figure51
1.Handle4.Drivelever
2.Neutral/parkingbrakelock
5.Forwardspeed
3.5to6mm(3/16to1/4
inch)clearance
6.Controlrod
37