Toro 41106 - User Manual

Questions and Answers:

G
Grant RogersSep 12, 2025
Why is a boom section not spraying on my Toro Paint Sprayer?
- B
  Barbara GarciaSep 12, 2025
  If a boom section isn't spraying on your Toro Paint Sprayer, consider these possibilities: * The electrical connection on the boom valve might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector on the valve, clean all leads, then reconnect it. * A fuse might be blown; check the fuses and replace them as necessary. * A hose might be pinched; repair or replace the hose. * A boom by-pass valve might be improperly adjusted; adjust the boom by-pass valves. * If the boom valve or electrical system is damaged, contact your Authorized Service Dealer.
D
Dale DavisSep 13, 2025
Why won't my Toro Paint Sprayer operate in either direction?
- G
  Gabriel GoodSep 13, 2025
  If your Toro Paint Sprayer won't operate in either direction: * Ensure the range selector is not in the Neutral position; press the brake and shift the range selector into a gear. * Make sure the parking brake was released and is releasing; release the parking brake or check the linkage. * If the transmission is broken, the control linkage needs adjustment or replacement, or the drive shaft or wheel hub key has been damaged, contact your Authorized Service Dealer.
S
Stacey BarajasSep 13, 2025
Why does my Toro 41106 Paint Sprayer monitor display 6553.5 in the Application Rate setting?
- D
  Donna TaylorSep 13, 2025
  If your Toro Paint Sprayer monitor displays 6553.5 when in the Application Rate setting, contact your Authorized Service Dealer because the monitor is not receiving data from the speed sensor.
J
james52Sep 13, 2025
What does “OFL” mean on my Toro 41106 Paint Sprayer monitor?
- S
  Shawn SchmidtSep 13, 2025
  If the monitor reads “OFL” on your Toro Paint Sprayer, it means the data has exceeded the maximum allowed. Press and hold the [Reset] button to clear the monitor.
J
Judy WilliamsSep 13, 2025
How to fix a Toro 41106 Paint Sprayer when the starter does not crank?
- J
  Jamie Ward MDSep 13, 2025
  If the starter on your Toro Paint Sprayer isn't cranking, make sure to press the brake pedal and shift the range selector to the Neutral position. Also, check the electrical connections to ensure they have good contact. Verify and, if necessary, replace the fuse. Finally, ensure the battery is adequately charged; if not, charge or replace it.
E
Evan WilsonSep 14, 2025
What to do if my Toro 41106 Paint Sprayer engine cranks but won't start?
- C
  Carl HarperSep 14, 2025
  If your Toro Paint Sprayer's engine cranks but doesn't start, begin by filling it with fresh fuel. If that doesn't work, drain and flush the fuel system before adding fresh fuel. Next, inspect the spark plug; clean or replace it if needed. Also, ensure the spark plug is properly reconnected and replace it if necessary.
C
Christine LunaSep 14, 2025
Why does my Toro 41106 engine start but not stay running?
- K
  Kenneth AndersonSep 14, 2025
  If the engine of your Toro Paint Sprayer starts but doesn't keep running, try replacing the fuel cap. Additionally, drain and flush the fuel system, then add fresh fuel. Another solution is to replace the fuel filter. Also, check and correct or replace the fuse. Finally, check and tighten the wire connections.
M
morganpatriciaSep 14, 2025
How to troubleshoot power loss in a Toro 41106 engine?
- A
  Alejandro OwenSep 14, 2025
  If your Toro Paint Sprayer engine loses power, start by ensuring the fluid levels are correct by filling or draining to the full mark. Next, clean or replace the components as needed. Also, drain and flush the fuel system, then add fresh fuel. Replace the spark plug and the fuel cap.
S
Sherry SheppardSep 14, 2025
What causes a Toro 41106 engine to knock or miss while running?
- E
  elizabeth91Sep 15, 2025
  If your Toro Paint Sprayer engine runs but knocks or misses, drain and flush the fuel system, then add fresh fuel. Reconnect the spark plug lead and replace the spark plug. Finally, check and tighten the wire connections.
K
Keith GlennSep 15, 2025
Why is my Toro Paint Sprayer engine overheating?
- D
  Denise BrownSep 15, 2025
  If your Toro Paint Sprayer engine overheats, ensure that the fluid levels are correct by filling or draining to the full mark. Reduce the load and use a lower ground speed. Clean the engine with every use.