Why does my Toro Sprayer engine run, but knocks or misses?
If your Toro Sprayer's engine runs but knocks or misses, it could be due to dirt, water, or stale fuel in the fuel system. In this case, drain and flush the fuel system, then add fresh fuel. Also, a loose spark plug lead could be the issue; reconnect it. Replacing a broken spark plug might also solve the problem. Make sure to check and tighten any loose wire connections.
How do I resolve abnormal vibration or noise in my Toro Sprayer?
Abnormal vibration or noise in your Toro Sprayer may be due to loose engine mounting bolts. Make sure to tighten the engine mounting bolts.
What causes a pressure drop when turning on a boom in my Toro Sprayer?
A pressure drop when you turn on a boom in your Toro Sprayer can be caused by an improperly adjusted boom bypass valve, so adjust the boom bypass valve. Additionally, check for obstructions in the boom valve body by removing the inlet and outlet connections to the boom valve and removing any obstructions. Inspect all nozzles for damage or clogs.
What to do if my Toro Sprayer engine will not idle?
If your Toro Sprayer engine won't idle, the fuel tank vent might be restricted, so replace the fuel cap. Dirt, water, or stale fuel in the fuel system can also cause this, so drain and flush the fuel system and add fresh fuel. Also, a damaged or broken spark plug can be the reason, so replace the spark plug. The air cleaner element might be dirty, so clean or replace it.
Why does my Toro Sprayer engine overheat?
Your Toro Sprayer engine may overheat if the crankcase oil level is incorrect; fill or drain to the full mark. Excessive loading can also cause overheating, so reduce the load and use a lower ground speed. Clean the air intake screens with every use. Check the cooling fins and air passages under the engine blower housing and/or the rotating air intake screen and clean with every use if they are plugged.
Why is my Toro Sprayer engine losing power?
If your Toro Sprayer engine is losing power, the crankcase oil level might be incorrect; fill or drain to the full mark. A dirty air cleaner element can also cause this, so clean or replace it. Additionally, dirt, water, or stale fuel in the fuel system could be the problem, so drain and flush the fuel system and add fresh fuel. Replace the spark plug if it is damaged or dirty. If the vent hole in the fuel tank vent fitting is plugged, replace the fuel cap.
What should I do if a boom section on my Toro Sprayer does not spray?
If a boom section on your Toro Sprayer does not spray, the electrical connection on the boom valve might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector on the valve, clean all leads, and then reconnect it. Also, check the fuses and replace them if necessary. A pinched hose can also cause this issue, so repair or replace the hose. Make sure that a boom by-pass valve is properly adjusted.
What to do if my Toro Sprayer machine will not operate or is sluggish?
If your Toro Sprayer machine will not operate or is sluggish because the engine bogs down or stalls, make sure that the parking brake is released.
What to do if my Toro Sprayer machine will not operate in either direction?
If your Toro Sprayer machine will not operate in either direction, ensure the range selector is not in the Neutral position by pressing the brake and shifting the range selector into a gear. Also, verify that the parking brake was released or is releasing; if not, release the parking brake or check the linkage.
What should I do if a boom section on my Toro Sprayer does not turn off?
If a boom section on your Toro Sprayer does not turn off, stop the spray system and pump, and turn off the sprayer. Remove the retainer from under the boom valve and pull out the motor and stem. Inspect all parts and replace any that appear damaged.
General| Max Pressure | 3000 PSI |
|---|---|
| Hose Length | 25 ft |
| Power Source | Electric |
| Spray Pattern | Adjustable |
| Voltage | 120V |
| Type | Airless |
| Nozzle Size | 0.015 in |
To Next Page
