How do I fix a Toro 41163 Paint Sprayer engine that will not idle?
If your Toro Paint Sprayer engine won't idle, replace the fuel cap. Also, drain and flush the fuel system, then add fresh fuel. Replace the spark plug and clean or replace components.
What to do if my Toro Paint Sprayer will not operate in either direction?
If the Toro Paint Sprayer does not operate in either direction, press the brake and shift the range selector into a gear. Also, release the parking brake or check the linkage.
Why is the speed on my Toro 41163 always 0 or erratic?
If the speed reading is always 0 or erratic on your Toro Paint Sprayer, connect the monitor cable and calibrate the speed sensor.
How to fix a boom section that does not spray on my Toro 41163 Paint Sprayer?
If a boom section on your Toro Paint Sprayer does not spray, manually turn the valve off. Disconnect the electrical connector on the valve and clean all leads, then reconnect it. Check the fuses and replace them if necessary. Repair or replace the hose, and adjust the boom by-pass valves.
What should I do if my Toro Paint Sprayer has abnormal vibration or noise?
If you notice abnormal vibration or noise in your Toro Paint Sprayer, tighten the engine mounting bolts.
What to do if Toro 41163 Paint Sprayer is sluggish because the engine bogs down?
If the Toro Paint Sprayer will not operate or is sluggish because the engine bogs down or stalls, release the parking brake.
How to troubleshoot a boom section that does not turn off on my Toro Paint Sprayer?
If a boom section on your Toro Paint Sprayer does not turn off, stop the spray system and pump, and turn off the sprayer. Remove the retainer from under the boom valve and pull out the motor and stem. Inspect all parts and replace any that appear damaged.
How do I fix a leaking boom valve on my Toro 41163 Paint Sprayer?
If a boom valve is leaking on your Toro Paint Sprayer, stop the spray system and pump and turn off the sprayer. Disassemble the valve and replace the O-rings.
What to do if my Toro 41163 Paint Sprayer engine cranks but will not start?
If your Toro Paint Sprayer engine cranks but won't start, consider these potential issues: * The fuel tank may be empty. Fill it with fresh fuel. * There might be dirt, water, or stale fuel in the fuel system. Drain and flush the fuel system, then add fresh fuel. * The fuel line could be clogged. Clean or replace it. * The spark plug lead might be disconnected. Reconnect the spark plug. * A spark plug could be damaged or dirty. Replace the spark plug. * The kill relay may not be energized; contact your Authorized Service Dealer. * The ignition could be broken; contact your Authorized Service Dealer.
Why don't the displayed measurements on my Toro 41163 Paint Sprayer make sense?
If the displayed measurements do not make sense on your Toro Paint Sprayer, check the Units of Measurement to ensure that it is set correctly.
General| Max Pressure | 3000 PSI |
|---|---|
| Hose Length | 25 ft |
| Power Source | Electric |
| Spray Pattern | Adjustable |
| Voltage | 120V |
| Type | Airless |
| Nozzle Size | 0.015 in |
To Next Page
