Leeco(R) Manual Feed Head Reassembly (cont’d)
5.
6.
7.
Figure
142
Place the spring on the cutter head shaft and
secure with the knob.
NOTE:
Rotate the knob counterclockwise to
tighten.
Reinstall the head assembly onto the drive shaft by
turning counterclockwise. Insert a medium blade
screwdriver into one
of
the slots shown in Figure
140
to prevent the drive shaft from rotating.
Cut
off
any excess line
so
that
it
does not strike the
shield.
60
n
To Next Page
Loading...
