Toro 74267 - User Manual

Questions and Answers

J
Jeffrey AlvarezSep 9, 2025
What to do if the blades do not rotate on my Toro 74267?
- O
  owalkerSep 10, 2025
  If the blades on your Toro Lawn Mower do not rotate, it could be due to a worn, loose, or broken drive belt, so check the belt tension. It could also be that the drive belt is off the pulley, so install the drive belt and check the adjusting shafts and belt guides for correct position. Another possibility is a worn, loose, or broken deck belt, so install a new deck belt. It may also be that the deck belt is off the pulley, so install the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Finally, a broken or missing idler spring could be the cause, so replace the spring.
N
Natalie PriceSep 8, 2025
Why aren't the blades rotating on my Toro 74267 Lawn Mower?
- J
  Jodi HorneSep 8, 2025
  If the blades of your Toro Lawn Mower do not rotate, it could be due to a worn, loose, or broken mower deck belt (install a new deck belt), the mower deck belt is off pulley (install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function), a worn, loose, or broken pump drive belt (check the belt tension or install a new belt), or a broken or missing idler spring (replace the spring).
W
woodsangelaSep 7, 2025
Why does my Toro Lawn Mower have an uneven cutting height?
- E
  eddie32Sep 7, 2025
  If your Toro Lawn Mower is resulting in an uneven cutting height, possible causes include: the blade(s) is/are not sharp (sharpen the blade(s)); the cutting blade(s) is/are bent (install new cutting blade(s)); the mower deck is not level (level the mower deck from side-to-side and front-to-rear); the underside of mower is dirty (clean the underside of the mower); the tire pressure is not correct (adjust the tire pressure); the blade spindle bent (contact an Authorized Service Dealer).
C
Cassandra JordanAug 22, 2025
Why won't my Toro Lawn Mower engine start?
- S
  stephanie25Aug 23, 2025
  If your Toro Lawn Mower engine won't start, struggles to start, or keeps cutting out, there are several potential causes: * The fuel tank may be empty, in which case you should fill it with fuel. * The air cleaner might be dirty; try cleaning or replacing the air cleaner element. * There could be dirt in the fuel filter, so replace the fuel filter. * If the issue persists, there may be dirt, water, or stale fuel in the fuel system, so contact an Authorized Service Dealer.
W
williamssandraSep 5, 2025
What to do if my Toro 74267 Lawn Mower blades do not rotate?
- N
  Nicole CochranSep 5, 2025
  If the blades on your Toro Lawn Mower do not rotate, check if the mower deck belt is worn, loose, or broken, and install a new deck belt if needed. If the mower deck belt is off the pulley, reinstall it and inspect the idler pulley, idler arm, and spring for correct position and function. Also, inspect the pump drive belt for wear, looseness, or breakage; check the belt tension or install a new belt. Finally, replace the idler spring if it's broken or missing.
J
Jasmine WallerSep 3, 2025
What to do if my Toro 74267 engine loses power?
- L
  Lindsey EstradaSep 3, 2025
  If your Toro Lawn Mower engine is losing power, there are several possible causes. First, reduce the ground speed if the engine load is excessive. Check the air cleaner and clean the element if it's dirty. Ensure the oil level in the crankcase is adequate, adding oil if it's low. Remove any obstructions from the cooling fins and air passages. Clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it's dirty.
M
mjonesSep 2, 2025
Why are the blades not rotating on my Toro Lawn Mower?
- T
  Thomas BrownSep 2, 2025
  If the blades on your Toro Lawn Mower are not rotating, here are a few things to inspect: * Check the belt tension if the drive belt is worn, loose, or broken. * Install the drive belt and check adjusting shafts and belt guides for correct position if the drive belt is off the pulley. * Install a new deck belt if the deck belt is worn, loose, or broken. * Install the deck pulley and check the idler pulley, idler arm, and spring for correct position and function if the deck belt is off the pulley. * Replace the spring if the idler spring is broken or missing.
G
Gary ParkSep 1, 2025
What to do if my Toro Lawn Mower does not drive?
- M
  Mary VasquezSep 1, 2025
  If your Toro Lawn Mower isn't driving, here are some potential causes: * Ensure the bypass valve is tightened. * Replace the drive or pump belt if it's worn, loose, or broken. * Reinstall the drive or pump belt if it has come off a pulley. * Replace the idler spring if it is broken or missing. * Add hydraulic fluid to the reservoir or let it cool down if the hydraulic fluid level is low or too hot.
D
Daniel RiveraAug 31, 2025
How to fix uneven cutting height on my Toro 74267?
- M
  Matthew AllenAug 31, 2025
  If your Toro Lawn Mower is leaving an uneven cutting height, consider these factors: * Sharpen the blade(s) if they are not sharp. * Install new cutting blade(s) if they are bent. * Level the mower from side-to-side and front-to-rear. * Clean the underside of the mower if it is dirty. * Adjust the tire pressure to the correct level. * If the blade spindle is bent, contact an Authorized Service Dealer.
L
Lori MontgomeryAug 29, 2025
Why is my Toro 74267 engine losing power?
- M
  Michael SmithAug 30, 2025
  If your Toro Lawn Mower engine is losing power, here are several things to check: * Reduce ground speed if the engine load is excessive. * Clean the air cleaner element if it is dirty. * Add oil to the crankcase if the oil level is low. * Clear any obstructions from the cooling fins and air passages above the engine. * Clean or replace the fuel cap if the vent hole is plugged. * Replace the fuel filter if there is dirt in it. * If the issue continues, there may be dirt, water, or stale fuel in the fuel system, so contact an Authorized Service Dealer.