Toro 74906 - Page 57

1
3
2
G017027
Figure92
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheight-adjustmentpinintothe7.6cm(3
inch)cutting-heightposition.
7.Releasethetransportlockandallowthedecktolower
tothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthelevel
surfacetothefronttipoftheblade(PostionA).The
measurementshouldread7.6mm(3inches);referto
Figure93.
Figure93
1.7.6cm(3inches)atAis
correct
3.Measureherefromthe
bladetiptohardsurface
2.8.3cm(3-1/4inches)atB
iscorrect
4.MeasureatAandBon
bothsides
10.Ifneeded,loosentheangedlocknutonthesideofthe
yokeandthejamnutontop.Fine-tunetheadjuster
screwbyturningittoget7.6mm(3inch)height
(Figure94).
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
G012430
1
2
2 1
3 4
Figure94
1.Flangedlocknut3.Jamnut
2.Adjusterscrew4.Yoke
11.Ifthefrontdecklinksdonothaveenoughadjustment
toachieveaccuratecutheight,thesinglepoint
adjustmentcanbeutilizedtogainmoreadjustment.
12.Toadjustthesinglepointsystem,loosenthe2boltsat
thebottomoftheheight-of-cutplate.RefertoFigure
95.
57