Toro 74906 - Page 58

1
g017029
Figure95
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow,tightenthesinglepoint
adjustmentboltbyrotatingitclockwise.Ifthedeckis
toohigh,loosenthesinglepointadjustmentboltby
rotatingitcounterclockwise(Figure96).
Note:Loosenortightenthesinglepointadjustment
boltenoughtomovetheheight-of-cutplatemounting
boltsatleast1/3thelengthoftheavailabletravel
intheirslots.Thiswillregainsomeup-and-down
adjustmentoneachofthe4decklinks.
g017036
Figure96
1.Singlepointadjustmentbolt
14.Tightenthe2boltsatthebottomoftheheight-of-cut
plate(Figure95).Torquethemto37to45N-m(27
to33ft-lb).
Note:Inmostconditions,thebackbladetipshould
beadjusted6.4mm(1/4inch)higherthanthefront.
15.Onbothsidesofthedeck,measurefromthelevel
surfacetothebacktipoftheblade(PostionB).The
measurementshouldread8.3cm(3-1/4inches);refer
toFigure93.
16.Fine-tunetheadjusterscrewbyturningittoget8.3
mm(3-1/4inches)height(Figure94).
Note:Toincreasetheheight,turntheadjustment
nutclockwise;todecreasetheheight,turnthenut
counterclockwise.
17.Measureuntilall4sidesarethecorrectheight.
18.Tightenallthejamnutsonthedeck-liftarmassemblies.
19.Lowerthedischargechute.
58