10
Connecting with the
Discharge T ube
Parts needed for this procedure:
1 Discharge tube
Procedure
1. Slide the curved end of the discharge tube into
the opening in the bagger top.
g010641
Figure 43
1. Discharge tube 4. Peg
2. Opening in bagger top
5. Rubber strap
3. Discharge tube, ared end
2. Slide the ared end of the discharge tube over
the end of the chute. Move the rubber retaining
strap on the chute over the peg on the discharge
tube to secure it.
3. After the bagger installation, install the wire onto
the spark plug(s).
1 1
Installing the Deck Ring
(Model 79390 Only)
Parts needed for this procedure:
4 Deck ring
8
Bolt (5/16 x 3/4 inch)
8
Locknut (5/16 inch)
Procedure
1. Install the interlocking deck rings to the bottom
of the mower deck.
g015226
Figure 44
1. Locknut (5/16 inch)
3. Deck ring
2. Bolt (5/16 x 3/4 inch)
2. Secure the rings to the deck using 8 bolts (5/16
x 3/4 inch) and 8 locknuts (5/16 inch).
22
To Next Page
Loading...
