Reelmaster 7000−D
Page 2 − 1
Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of Contents
PRODUCT RECORDS 1.........................
MAINTENANCE 1..............................
EQUIVALENTS AND CONVERSIONS 2...........
Decimal and Millimeter Equivalents 2............
U.S. to Metric Conversions 2...................
TORQUE SPECIFICATIONS 3...................
Fastener Identification 3.......................
Using a Torque Wrench with an Offset Wrench 3..
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Inch Series) 4...............
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Metric Fasteners) 5..........
Other Torque Specifications 6..................
Conversion Factors 6.........................
Product Records
Insert Operator’s Manuals and Parts Catalog for your
Reelmaster at the end of this chapter. Additionally, insert
Installation Instructions, Operator’s Manuals and Parts
Catalogs for any accessories that have been installed
on your Reelmaster at the end of this section.
Maintenance
Maintenance procedures and recommended service in-
tervals for your Reelmaster are covered in the Traction
Unit and Cutting Unit Operator’s Manuals. Refer to
those publications when performing regular equipment
maintenance. Several maintenance procedures have
break−in intervals identified in the Operator’s Manuals.
Refer to the Engine Operator’s Manual for additional en-
gine specific maintenance procedures.
Product Records
and Maintenance
To Next Page
Loading...
Need help?
General
