Reelmaster 7000−D Page 8 − 19 Chassis
Removal (Fig. 15)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Release hood latches and raise hood.
3. Remove hair pins and washers from pivot pins on ra-
diator frame.
4. Remove hood from pivot pins and machine.
5. If necessary, disassemble hood.
Installation (Fig. 15)
1. If components were removed from hood, assemble
hood.
2. Slide hood frame onto radiator frame pivot pins.
3. Secure hood to frame with hair pins and washers.
4. Check hood alignment for correct operation of hood
latches and dust seals.
Chassis
To Next Page
Loading...
Need help?
General
