Greensmaster 1000/1600Page 7 – 12Cutting Unit
Grass Shield Height Adjustment
" ! ! "
! ! !
1. Park mower on a level surface. Make sure engine
is OFF. Remove high tension lead from the spark plug.
2. " ! ! ! ! ! "!
! ! ! ! ! "!! "!
3. ! ! "! ! ! ! !
"!! ! "
Note: $ ! &
% # ! ! ! $ #%
$! ! " " &
!
4. $ "! "
! ! ! ! " ! ! ! !
! !! !
1. Support rod 2. Shield
Figure 16
1
2
1. Grass shield
2. Cap screw
3. Lock nut
4. Side plate
Figure 17
2
3
4
1
Cutoff Bar Adjustment
Adjust cutoff bar to assure clippings are cleanly dis-
charged from the reel area.
Note: The cutoff bar is adjustable to compensate for
changes in turf conditions. The bar should be adjusted
closer to the reel for extremely wet turf. However, adjust
cutoff bar further away from the reel for dry turf. The bar
should be parallel to the reel to assure optimum perfor-
mance. Make sure cutoff bar is adjusted whenever the
shield height is adjusted or the reel is sharpened.
1. Park mower on a level surface. Make sure engine
is OFF. Remove high tension lead from the spark plug.
2. Loosen screws securing the cutoff bar. Insert a
0.060 inch (0.152 mm) feeler gauge between the top of
the reel and the bar.
3. Tighten screws so that the distance between the
cutoff bar and reel is equal for the complete length of the
reel.
1. Screw 2. Cutoff bar
Figure 18
2
1
To Next Page
Loading...
