Toro Greenmaster 1000 - Handle and Wheel Adjustments

Greensmaster 1000/1600
Page 6 – 3
Wheels and Accessories
Adjustments
Handle Height Adjustment
1. Make sure mower is parked on a level surface with
the engine OFF.
2. Remove cotter pins from the ring pins on each side
of the mower.
3. Support handle, and remove ring pins from each
side of the mower. Raise or lower handle to the desired
operating position.
4. Reinstall ring pins and cotter pins.
1. Cotter pin 2. Ring pin
Figure 1
1
2
Wheels and
Accessories