Toro Greensmaster 1021 - Filling the Fuel Tank; Adjusting the Clip Rate; Adjusting the Reel Speed

FillingtheFuelTank
1.Cleanaroundthefuel-tankcapandremovethe
capfromthetank(Figure12).Fillthefueltank
tothebottomofthetank-neckopening;referto
yourengineOperator’sManual.
Important:Donotoverllthetankwithfuel.
g265976
Figure12
1.Fuel-tankcap
2.Installthefuel-tankcapandwipeupanyspilled
fuel.
AdjustingtheClipRate
Thecliprateisdeterminedbythefollowingmachine
settings:
•Reelspeed:Youcanadjustthereelspeedtoa
highorlowsetting;refertoAdjustingtheReel
Speed(page13).
•Reel-drive-pulleyposition:Youcansetthe
reel-drivepulleysin2positions;refertoyour
cuttingunitOperator’sManual.
Todeterminethereelspeedandreel-drive-pulley
positionfortheappropriateclip,refertothefollowing
table:
ClipRate
CuttingUnit
Reel
Speed
Belt
Position
8-blade11-blade14-blade
LowLow7.3mm
(0.286inch)
5.3mm
(0.208inch)
4.2mm
(0.164inch)
LowHigh8.7mm
(0.241inch)
4.4mm
(0.175inch)
3.5mm
(0.137inch)
HighLow5.9mm
(0.233inch)
4.3mm
(0.169inch)
3.4mm
(0.133inch)
HighHigh5.0mm
(0.196inch)
3.6mm
(0.142inch)
2.8mm
(0.112inch)
AdjustingtheReelSpeed
Usethereel-speed-controlknob(Figure13)toadjust
thereelspeed.
•Highreelspeed:Rotatetheknobsothatthe“H”
ontheknobisdirectedtowardthefrontofthe
machine.
•Lowreelspeed:Rotatetheknobsothatthe“L”
ontheknobisdirectedtowardthefrontofthe
machine.
13