Toro Greensmaster 1021 - Tightening the Handle-Isolation Hardware; Cutting Unit Maintenance; Blade Safety; Installing the Cutting Unit

Tighteningthe
Handle-IsolationHardware
ServiceInterval:Aftertherst20hours
1.Positionthemachineonalevelsurface.
2.LoosentheboltandnutasshowninFigure33.
g289358
Figure33
1.Bolt2.Nut
3.Pushthehandleasfarforwardaspossible.
4.Whilesupportingthehandle,torquetheboltand
nutthatyouloosenedinstep2to91to111Nm
(67to82ft-lb).
Note:Haveanassistanthelpyoutosupport
thehandleortorquethehardware.
5.Releasethehandle.
CuttingUnitMaintenance
BladeSafety
Usecarewhencheckingthecutting-unitreel.Wear
glovesandusecautionwhenservicingthereel.
Awornordamagedbladeorbedknifecanbreak,and
apiececouldbethrowntowardyouorbystanders,
resultinginseriouspersonalinjuryordeath.
•Inspectthebladesandbedknivesperiodicallyfor
excessivewearordamage.
•Usecarewhencheckingtheblades.Weargloves
andusecautionwhenservicingthem.Only
replaceorbacklapthebladesandbedknives;
neverstraightenorweldthem.
InstallingtheCuttingUnit
1.MovethekickstandtotheCUTTING-UNIT-SERVICE
position;refertoKickstand(page10).
2.Alignthecuttingunittotheframe.
3.Use4socket-headscrewstosecurethecutting
unittotheframe(Figure34).
g304659
Figure34
1.Socket-headscrew2.Cutting-unit-drivecoupler
28