Toro Groundsmaster 4100-D 30411 - Page 25

below)ontothespindleshafttogetthedesired
height-of-cut;thenslidethewasherontotheshaft.
Refertothefollowingcharttodeterminethe
combinationsofspacersforthesetting:
Figure15
4.Pushthecastorspindlethroughthefrontcastor
arm.Installtheshims(astheywereoriginally
installed)andtheremainingspacersontothe
spindleshaft.Installthetensioningcaptosecure
theassembly.
5.Removethehairpincotterandclevispinsecuring
theheight-of-cutchainstotherearofthecutting
unit(Figure16).
Figure16
1.Height-of-cutchain
2.U-bolt
6.Mounttheheight-of-cutchainstothedesired
height-of-cuthole(Figure17)withtheclevispin
andhairpincotter.
Figure17
Note:Whenusing1inch(25mm),1-1/2inch(38
mm),oroccasionally2inch(51mm)height-of-cut,
movetheskidsandgagewheelstothehighestholes.
WingCuttingUnits
Toadjusttheheight-of-cutonthesidecuttingunits,add
orremoveanequalnumberofspacersfromthecastor
forks,positionthecastorwheelaxlesinthehighorlow
height-of-cutholesinthecastorforks,andsecurethe
pivotarmstotheselectedheight-of-cutbracketholes.
1.Positionthecastorwheelaxlesinthesameholes
inallofthecastorforks(Figure18andFigure20).
Refertothefollowingcharttodeterminethe
correctholeforthesetting.
2.Removethetensioningcapfromthespindleshaft
(Figure18)andslidethespindleoutofcastorarm.
Putthetwoshims(1/8inch[3mm])ontospindle
shaftastheywereoriginallyinstalled.Theseshims
arerequiredtoachievealevelacrosstheentire
widthofthecuttingunits.Slidetheappropriate
numberof1/2inchspacersontothespindleshaft
togetthedesiredheight-of-cut;thenslidethe
washerontotheshaft.
25