Toro Groundsmaster 7200 Series - Brake Maintenance; Adjusting Parking-Brake Interlock Switch

BrakeMaintenance
Adjustingthe
Parking-BrakeInterlock
Switch
1.Stopthemachine,movethemotion-control
leverstotheNEUTRAL-LOCKposition,engagethe
parkingbrake,andremovetheignitionkey.
2.Removetheboltssecuringthefrontpaneland
removethepanel(Figure45).
g020875
Figure45
1.Bolt
2.Controlpanel
3.Loosenthe2jamnutssecuringtheparking-brake
interlockswitchtothemountingbracket.
g031811
Figure46
1.Brake-shaftsensor
3.Jamnut
2.4mm(5/32inch)
4.Parking-brakeinterlock
switch
4.Movetheswitchupordownonthebracketuntil
thedistancebetweenthebrake-shaftsensor
andtheswitchplungeris4mm(5/32inch)as
showninFigure46.
Note:Makesurethatthebrake-shaftsensor
doesnotcontacttheswitchplunger.
5.Securetheswitchjamnuts.
6.Testtheadjustmentasfollows:
A.Ensurethattheparkingbrakeisengaged
andyouarenotsittingontheseat,then
starttheengine.
B.Movethecontrolleversoutofthe
NEUTRAL-LOCKposition.
Note:Theengineshouldshutoff.Ifnot,
checktheadjustmentthatyoumadetothe
switch.
7.Installthefrontpanel.
47