Toro Multi Pro 5800 - Page 63

Figure85
1.Flange(pressurelter
head)
5.Gasket
2.Manifold(agitationvalve)6.3-pinconnector(valve
actuator—agitationvalve)
3.Flange(bypass
valve—agitationvalve)
7.Flange(masterboom
valve)
4.Clamp
2.Removetheanged-headboltandangedlocknutthat
securestheagitationvalvetothevalvemountand
removethevalvemanifoldfromthemachine(Figure
86).
Figure86
1.Flanged-headbolt3.Valvemount
2.Manifold(agitationvalve)
4.Flangedlocknut
RemovingtheMasterBoomManifold
Valve
1.Removeclampsandgasketsthatsecurethemanifold
forthemasterboomvalve(Figure87)tothemaster
boombypassvalve,agitationvalve,and90°anged
elbow(attheendofthehosefortheowmeter).
Note:Retaintheclamp(s)andgasket(s)forinstallation
inInstallingtheMasterBoomManifoldValve(page
68).
Figure87
1.Flange(bypass—master
boomvalve)
5.90°angedelbow
2.Flange(agitationvalve)6.3-pinconnector(valve
actuator—masterboom
valve)
3.Clamp7.Manifold(masterboom
valve)
4.Gasket
2.Removetheanged-headboltandangedlocknutthat
securesthemasterboomvalvetothevalvemountand
removethevalvemanifoldfromthemachine(Figure
88).
63