7-3Power Max Service Manual
Fig 080 MVC-003F
8. Loosen the 2 set screws on the auger pulley. A long
extension and a ratchet will be necessary
(Fig. 080).
Fig 079 MVC-011X
7. Remove the crankshaft pulley capscrew (Fig. 079),
the front section of the pulley and the belt.
9. Remove two capscrews on each side that secure the
auger bearings to the auger side plate (Fig. 081).
10. Disconnect the spring on both ends of the pivoting
scraper (Fig. 082).
Fig 082 MVC-787F
AUGER GEARBOX
Fig 081 MVC-769X
To Next Page
Loading...
