Replacing the Hydraulic Filters (continued)
G437171
3. At the left side of the machine, align a drain
pan under the charge filter
.
4. Remove the filter.
5. Wipe clean the filter mounting area of the filter
head
.
6. Apply a thin coat of the specified hydraulic fluid
to the gasket of the new charge filter.
7. Thread the filter onto the filter head by hand
until the gasket contacts the mounting surface,
then rotate the filter an additional 1/2 turn.
8. Lower and latch the seat.
Checking for Leaks
1. Start the engine and run it for 2 minutes to purge air from the hydraulic system.
2. Shut off the engine, remove the key, and check for leaks at the return and charge filters.
Note: Repair all hydraulic leaks.
Maintenance: Hydraulic System Maintenance Page 6–35 3464-490 A
To Next Page
Loading...
