g018444
Figure 29
Lower Discharge T ube Latch
1. Blower assembly 3. Latch
2. Upper latch
6. Make note of where the 2 bolts in the upper tube
are installed.
Note: The hole near the molded arrowheads
will not be used.
7. Remove the 2 bolts in the lower end of the upper
tube.
8. Use the 2 holes as a template for the lower tube.
Note: Retain the hardware.
9. Insert the upper end (no holes) of the upper tube
through the tube seal in the hood by pushing
the tube in until the tube contacts the inside of
the hood.
10. Pull the upper tube out slightly so that the seal
extends outward and over the lower tube ( Figure
30 ).
g018440
Figure 30
1. Upper tube 3. Bagger hood
2. Rubber seal protruding out
1 1. Align the upper tube holes to match the dimples
on the surface of the lower tube.
Note: Ensure that the side prole appears as
shown in Figure 31 .
Note: Do not use the open hole near the
molded arrowheads.
g020776
Figure 31
1. Upper tube
3. Notch at the bottom of the
tube when installed
2. Existing hole (bolt
removed)
4. Lower tube
20
To Next Page
Loading...
