Toro UTV700AAC00000 - Page 102

100
CF088A
10. Remove the two cap screws securing the gear posi-
tion switch; then remove the switch.
11. Remove the nut (left-hand threads) securing the
clutch shoe assembly (C).
PR410A
12. Remove the cap screw securing the oil pump drive
gear (B). Account for a cap screw, washer, pin, and
spacer.
CC606
CD987
CD993
13. Using an impact wrench, remove the cap screws
securing the final drive carrier bearing housing (E);
then remove the housing and account for two align-
ment pins.
CD999
14. Remove the snap ring securing the oil pump driven
gear (A); then remove the gear noting the direction
of the sides of the gear for installing purposes.
Account for a pin and a washer.