11
HDX238A
2. Remove the muffler by pulling it rearward out of the
vehicle.
3. Remove the heat shield.
HDX241A
4. Remove the three cap screws securing the exhaust
pipe/spark arrester assembly to the muffler.
HDX243A
5. Using a wire brush, clean the carbon deposits from
the screen taking care not to damage the screen.
HDX242
NOTE: If the screen or gasket is damaged in any
way, it must be replaced.
6. Install the exhaust pipe/spark arrester assembly and
secure with the three cap screws. Tighten to 6.8 N-m
(60 in.-lb).
7. Install the heat shield and tighten the fasteners to 8.1
N-m (72 in.-lb).
8. Install the muffler and secure it to the exhaust pipe
with the two springs.
Engine/Transmission Oil -
Filter
Change the engine oil and oil filter at the scheduled inter-
vals. The engine should always be warm when the oil is
changed so the oil will drain easily and completely.
1. Park the vehicle on level ground.
2. Remove the seat; then remove the backrest and seat
base.
3.
Loosen the oil fill cap using a 27 mm socket (700) or
oil level stick (500). Be careful not to allow contami-
nants to enter the opening.
HDX042A
700
To Next Page
Loading...
