59
FI547
11. Install two alignment pins and a gasket on the mag-
neto cover; then install the water pump housing
assembly. Tighten the cap screws to 8 ft-lb.
FI541A
FI539
12. Install the water pump cover with a new O-ring and
secure with the four cap screws. Tighten to 8 ft-lb.
FI538
13. Connect the coolant hoses to the water pump and
secure with the hose clamps. Tighten securely.
Right-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. If the engine is still in the frame, remove the cap
screw securing the brake pedal to the pedal axle.
Account for a flat washer.
KC149A
2. Remove the cap screws securing the V-belt cover to
the clutch cover; then slide the brake pedal outward
and remove the V-belt cover. Account for two align-
ment pins and a gasket.
AT THIS POINT
To service center crankcase components only, proceed
to Removing Right-Side Components.
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
To Next Page
Loading...
