150
GC015
2. Using a T-40 torx wrench, remove the cap screws
securing the differential cover. Account for and make
note of the ID tag location for assembling purposes.
GC003
3. Using a plastic mallet, tap lightly to remove the dif-
ferential cover. Account for an O-ring.
KX174
NOTE: If the cover is difficult to remove, pry on the
cover in more than one recessed location.
4. Remove the splined coupler, shifter fork, pin, and
spring of the differential lock assembly and set aside.
Note position of parts for assembling purposes.
KX175
5. Remove the left differential bearing flange assembly
and account for a shim. Mark the shim as left-side.
KX177
KX178
6. Place the differential with the open side down; then
lift the housing off the spider assembly. Account for
shim(s) and mark as right-side.
KX179
To Next Page
Loading...
