155
6. Install the shift fork shaft w/spring into the housing
making sure the shaft O-ring is positioned to the
inside.
CC892
7. Install the shift fork assembly making sure the fork
leg is facing upward. Apply a small amount of oil to
the gasket; then install the gasket.
CC893
8. Place the input shaft assembly onto the gear case
housing; then secure with the existing cap screws.
Tighten to 23 ft-lb.
NOTE: If a new housing is being installed, tighten
the cap screws to 28 ft-lb.
CD103
CD110
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
CC899
NOTE: Prior to installing the seal, apply High-Per-
formance #2 Molybdenum Disulphide grease to the
seal outside diameter.
2. Using Gear Case Seal Installer Tool, evenly press the
seal into the cover bore until properly seated.
CF278
3. Repeat steps 1-2 for the opposite side.
CAUTION
Make sure the tool is free of nicks or sharp edges or
damage to the seal may occur.
To Next Page
Loading...
