Toro UTV700AAC00000 - Page 41

39
HDX147A
13. Remove the forward heat shield from the exhaust
pipe; then remove the cap screws securing the
exhaust pipe to the cylinder head.
HDX152A
HDX154
14. Disconnect the O2 sensor; then remove the O2 sensor.
HDX247
15. Remove the two exhaust springs at the muffler; then
remove the exhaust pipe. Account for a grafoil seal
in the cylinder head and a grafoil seal at the muffler.
HDX153A
16. Remove the cap screws securing the driveshafts to
the front and rear engine flanges; then disconnect
the upper and lower coolant hoses.
HDX158A
HDX159A
17. Disconnect the oil cooler lines and plug them to
prevent oil spillage.
18. Remove the nuts from the rear engine mounts;
then remove the front through-bolt.