66
MD1068
KC134
13. Slide the fixed drive face assembly onto the front
shaft.
14. Spread the faces of the driven pulley by threading a
V-belt cover cap screw into the fixed driven face and
tightening until the faces open sufficiently to allow
the V-belt to drop into the pulley approximately 3/4
in.
KC137
NOTE: The arrows on the V-belt should point in
direction of engine rotation.
15. Making sure the movable drive face rollers are in
position, pinch the V-belt together near its center and
slide the spacer and movable drive face onto the
shaft.
KC127
16. Coat the threads of the nut with red Loctite #271;
then making sure the splines of the clutch shaft pro-
trude through the cover plate, secure with the nut and
tighten to 147 ft-lb.
KC138
KC141
NOTE: At this point, the cap screw can be removed
from the driven pulley face.
17. Rotate the V-belt and drive/driven assemblies until
the V-belt is flush with the top of the driven pulley.
18. Install two alignment pins and place a new V-belt
cover gasket into position on the clutch cover. In a
crisscross pattern, tighten cap screws to 8 ft-lb.
To Next Page
Loading...
