Workman GTX Gasoline Page 6 -- 47 Chassis
Removal (Fig. 45)
1. Park vehicle on a level surface, stop engine, set
parking brake and remove key from the key switch.
2. Remove front fenders, hood or front bumper using
Figure 45 as a guide.
Installation (Fig. 45)
NOTE: Do not fully tighten fasteners securing body
components until all fasteners are in place.
1. Install removed body components using Figure 45
as a guide. During assembly, use fastener torque speci-
fications that are identified in Figure 45.
Chassis
To Next Page
Loading...
