Unlatching the Seat
Push the seat latch rearward to unlatch the seat.
This vdll allow access to the machine under the
seat (Figure 26).
2
1. Seat latch
2. Fuel cap
Figure 26
3. Seat
3
G000950
Pushing the Machine by
Hand
Important: Always push the machine
by hand. Never tow the machine because
hydraulic damage may occur.
Pushing the Machine
,
,
Disengage the power take off (PTO) and
turn the ignition key to off. Move the levers
to neutral locked position and apply paring
brake. Remove the ke>
Rotate the by-pass valves counterclockvdse
1 turn to push. This allows hydraulic fluid to
by-pass the pump enabling the wheels to turn
(Figure 27).
Important: Do not rotate by-pass valves
more than 1 turn. This prevents valves
from coming out of the body and causing
fluid to run out.
3. Disengage paring brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to
operate machine (Figure 27).
Note: Do not over tighten the by-pass valves.
The machine will not drive unless by-pass valves
are turned in.
2
3 2
G000966
Figure 27
1. Side console controls 3. Hydraulic pumps
2. By-pass valve
Using the Side Discharge
The mower has a hinged grass deflector that
disperses clippings to the side and down toward
the turf.
26
To Next Page
Loading...
