them more frequently under extremely dusty or
dirty conditions.
Replacing the Fuel Filter
Ensure that an Authorized Service Dealer replaces
the fuel filter and any components for the fuel
system.
Use of improper components can result in
system failure, fuel leakage and possible
explosion.
• Ensure that an Authorized Service
Dealer replace the fuel filter and any
components for the fuel system.
• Use only approved fuel lines, hose
clamps and fuel filters for high pressure
systems.
Servicing the Fuel Tank
Do not attempt to drain the fuel tank. Ensure that
an Authorized Service Dealer drains the fuel tank
and services any components of the fuel system.
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes severe
burns.
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
Removing the Battery
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to
touch any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of
the machine.
Electrical System
Maintenance
Servicing the Battery
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
Incorrect battery cable routing could
damage the machine and cables causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• Always Disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always Reconnect the positive (red)
battery cable before reconnecting the
negative (black) cable.
,
,
,
4.
Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
Stop the engine, remove the ke5 and wait for
all moving parts to stop before leaving the
operating position.
Unlatch the seat and tilt the seat up.
First disconnect the negative battery cable from
the negative (-) battery terminal (Figure 43).
37
To Next Page
Loading...
