Slide the red terminal boot off the positive
(red) battery terminal. Then remove the
positive (red) battery cable (Figure 43).
4
3
2
5
\
\,
4
3
2
G000959
Figure 43
1. Negative Battery Post 3. Red (+) cable
2. Positive Battery Post 4. Black (-) cable
6. Remove both wing nuts (1/4 inch) securing
the battery clamp (Figure 44).
7. Remove the two bolts holding the hydraulic
tank in place (Figure 44).
8. Slide the hydraulic tank away from the batter 7
9. Remove the battery.
G001050
1. Battery
2. Hydraulic tank
3. Bolts
Figure 44
4. Wing nut
5. Right side fuel tank
Installing the Battery
1. Position battery in the tray with the terminal
posts opposite from the hydraulic tank
(Figure 43)•
2. First, install the positive (red) battery cable to
positive (+) battery terminal.
3. Then install the negative battery cable and
ground wire to the negative (-) battery terminal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inch),
2 washers (1/4 inch), and 2 locknuts (1/4 inch)
(Figure 43)•
5. Slide the red terminal boot onto the positive
(red) battery post•
6. Secure battery with J-bolts, hold down clamp
and 2 washers (1/4 inch), and 2 wing nuts
(1/4 inch) (Figure 44).
38
To Next Page
Loading...
