Toro Z593-D Z Master 74264 - Replacing and Tensioning the Alternator Belt; Replacing the Pump Drive Belt

2
4
5
4
Figure 58
6
1
G001157
2
1. PTO Drive belt 4. Spring loaded idler pulley
2. Clutch 5. Gear box
3. Spring 6. Clutch stop bracket
Replacing the Pump Drive
Belt
Check pump drive belt for wear after every
50 hours of operation.
Note: Remove the PTO drNe belt first if the
pump drNe belt needs to be replaced.
1. Tilt the seat forward and remove the front
engine panel.
2. Remove the PTO drive belt.
3. Remove the spring from the idler arm
(Figure 59).
4. Install the new belt around the engine and
hydro pump pulley (Figure 59).
5. Install the PTO drive belt.
6. Install the spring to the idler arm (Figure 59).
G001158
\
3
Figure 59
1. Pump drive belt 3. Spring loaded idler pulley
2. Clutch 4. Spring
Replacing and Tensioning
the Alternator Belt
Check the alternator belt for wear after every
)
( hours of operation.
Replacing the Alternator Belt
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parMng brake.
2. Stop the engine, remove the ke}, and wait for
all moving parts to stop before leaving the
operating position.
3. Remove the 4 bolts holding the oil cooler
shield to the rear frame (Figure 60).
4. Remove the 3 bolts holding the engine straps
to the side of the machine (Figure 60).
46