To make an IFC slave card:
v Store a serial number of 55-55555.
Addressing
The printer supports standard Internet Protocol version 4 (IPv4) addressing. The IP
address and other IP network parameters are assigned using the following list of
priorities:
1. Fixed, if enabled and defined for the fixed IP selected.
2. Dynamic Host Configuration Protocol (DHCP), if the previous assignment
method does not apply and a DHCP server is available.
3. Auto IP, if neither of the previous assignment methods apply and Auto IP is
enabled.
When Fixed IP and Auto IP are disabled, the printer will wait for a valid DHCP
server.
Table 3. Provided ports
Port Protocol Service Comments
80 TCP HTTP
161 UDP SNMP Version 1 and 2 are supported.
162 TCP/UDP SNMP Trap
9100 UDP Printer Control Used for reservation and other control function.
TCP PDL Data
Stream
Used to send RAW printer data to a printer.
DHCP
Dynamic Host Configuration Protocol (DHCP) is the default IP configuration method
(see “Addressing” on page 7 for more information). DHCP will be implemented
according to Request for Comments (RFC) 2131, Dynamic Host Configuration
Protocol, RFC 2132, DHCP Options and BOOTP Vendor Extensions, and applicable
updates. These specifications and applicable updates may be found at
http://datatracker.ietf.org/.
Table 4. Supported DHCP options
Tag Name
1 Subnet Mask
3 Router
6 Domain Name Server
12 Hostname
Auto IP
Auto IP is a method for a host to assign itself a Local Link IP address, described in
RFC 3927. The printer will randomly select an address from the range 169.254.1.0
to 169.254.254.255 and verify that it is not in use.
Auto IP can be disabled when the user determines that the printer should always
have a valid server. This will keep the printer from setting up an auto IP when the
server is temporarily unavailable.
Chapter 1. Introducing the 4610 Models 1NR, 1NA, and 1ND 7
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||
||||
||||
||||
||||
|||
|
|
|
|
|
|
|
|
|
|
|
|
||
||
||
||
||
|
|
|
|
|
|
|
|
To Next Page
Loading...
