430 Series
5. Remove the tape from the speaker cable and disconnect the speaker cable
from PJ6 on the sound board.
6. Disconnect the sound board power cable from PJ9 on the sound board.
7. Disconnect the CD-ROM sound cable from PJ11 on the sound board.
8. Press up on the sound board flexible cable evenly to disconnect it from PJ7 on
the system board. Lift out the sound board.
9. Disconnect the sound board power cable from PJ18 on the system board
(located under left side of power supply cover - this cover is not removed until
section 4.12.)
Figure 4-32 Removing the sound board
10. Unlatch the audio jack cover and remove it.
11. Lift off the tape securing the membrane switch, disconnect the membrane
switch cable from PJ10 and lift out the switch.
Figure 4-33 Removing the membrane switch
To Next Page
Loading...
