430 Series 4-55
6. Carefully lift the FL out of the FL unit. The FL is fragile, be sure to not exert
undue pressure which could cause it to snap.
Figure 4-52 Removing the FL (DSTN)
Installing the FL (DSTN)
To install the FL, follow the steps below and refer to Figures 4-52 and 4-51.
1. Seat the FL and gently press it securely in place.
2. Secure four latches.
3. Secure two M2x6 silver screws.
4. Install the LCD module, FL inverter board, display mask, optional PC card, optional
memory module and the battery pack as described in Sections 4.20, 4.18, 4.16, 4.4,
4.3, and 4.2.
To Next Page
Loading...
