Toshiba B-EP4DL-GH20-QM-R - 3.2.4 HOW TO SEND THE DATA PRINT COMMAND WHICH CANNOT BE INCLUDED IN ONE PACKET IN THE LABEL MODE

CHAPTER 3 INTERFACE
B-EP Series
3-11
3.2.4 HOW TO SEND THE DATA PRINT COMMAND WHICH CANNOT BE INCLUDED IN ONE
PACKET IN THE LABEL MODE
When the Data Print Command in the LABEL mode cannot be included in one packet (256 bytes
or more in 1-byte length designation, 4096 bytes or more in 2-byte length designation), it can be
included in several packets by using the multiple packet format for the Data Print Command,
described on page 3-7.
Conditions: Data length for the Bit Map Font Field Command, the Outline Font Field Command,
and the Barcode/Two-dimensional Code Format Command, should be fixed at “00”.
For the JIS 8 and Shift JIS Kanji codes only.
(Example) To include the Data Print Command below into several packets:
X [01H] [01H] [01]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
Command packet 1
[STX] [00H] [00H] [DEH] Y [80H] X [01H] [01H] [01H]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
[CRC] [CRC]
Command packet 2
[STX] [00H] [00H] [DAH] Y [01H]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF] ABCDEFGHIJKLMNOPQRSTUVWXYZ [LF]
[CRC] [CRC]