Toshiba B-FV4T-GS12-QM-R - Print Quality and Ribbon Problems

5TroubleshootingToshibaB‐FV4TOwner’ sManual
36
 The media is not loaded correctly.See Section 2.3,“Loading Media” to reload
themedia.
 The media sensor needs to be calibrated. See Section 3.1, “Media Sensor
Calibration”tocalibratethesensor.
 Themediasensorisdirty.Cleanthemediasensor.
Nothingisprinted
 The media is not loaded correctly.See Section 2.3,“Loading Media” to reload
themedia.
 Theribbonisnotloadedcorrectly.See Section2.4,“LoadingRibbon”toreload
theribbon.
 The print data might not be sent successfully. Make sure the interface is set
correctlyintheprinterdriver,andsendtheprintdataagain.
Theprintqualityispoor
 Theprintheadisdirty.Cleantheprinthead.
 Theplatenrollerisdirty.Cleantheplatenroller.
 Adjusttheprintdarkness,orlowertheprintspeed.
 Themediaisincompatiblefortheribbon.Usethecompatiblemediainstead.
 The media is incompatible for the printer. Use Tos hiba‐approved media roll
instead.
5.3RibbonProblems
Theri bbonisout
 Loadanewribbonroll.
Theri bbonisbroken
 Check the print darkness and adjust it if it is too high, and take the following
stepstofixthebrokenribbon: