Toshiba B-FV4T-GS12-QM-R - Other Issues: USB and Errors

5TroubleshootingToshibaB‐FV4TOwner’ sManual
37
1. Unloadtheribbonsupplyrollandtak e‐uprollfromtheprinter.
2. Pulltheribbonfromthesupplyrollsoitoverlapsthebrokenendofthetake‐up
roll.
3. Tapetheoverlappedpartstogether.
4. Reloadbothrollsintotheprinter.
Theri bbonis“printedout”withthemedia
 Theribbonisnotloadedcorrectly.See Section2.4,“LoadingRibbon”toreload
theribbon.
 The printhead temperature is too high. Reload the ribbon and print a
configuration labeltocheckthe settings(see Section3.2, “SelfTestand Dump
mode”).Iftheprintdarknessisveryhigh,adjustitinprinterpreference,orreset
yourprinter(seeSection3.3,“RestoreYourPrintertoFactorySettings”).
Theri bboniswrinkled
1. Makesuretheribbonisloadedcorrectly.
2. RotatetheTake‐UpWheeltostraightentheribbon.
5.4OtherProblems
Therearebrokenlinesintheprintedlabel
 Theribboniswrinkled.Adjustorreloadtheribbon.Or,printa few labelsuntil
thewrinkledpartgoesaway.
 Theprintheadisdirty.Cleantheprinthead.
AnerroroccurredwhenwritingdatatotheUSBmemory
 DidyouinserttheUSBdrive?
 MakesuretheUSBdriveispluggedtightlyintotheport.
 TheUSBdrivemightbebroken.Replaceitwithanotherone.
TheprinterisunabletosavefilesduetoinsufficientUSBmemory