143
Recording Playback EditingIntroduction Connections Basic Setup
Function Setup
Others
EN
7
Using [K / L], select “Yes”. Press [ENTER]
within 15 seconds.
Your setting will be activated.
8
Press [SETUP] to exit.
Video - Progressive
Confirm again to use progressive scan.
If Picture is good, Select “Yes”.
No
Yes
Notes
• If your TV is compatible with Progressive Scan (525p / 480p), you must use the Component Video cable (commercially
available) to connect this unit to the TV. (See Method 2 on page 25.) Make sure the “P.SCAN” appears on the front panel
display.
If not, use the video cable and set the Progressive Scan mode to “OFF”, or press and hold [SETUP] for more than 3
seconds during DVD playback, so that the “P.SCAN” on the front panel display disappears.
• If there is no picture or picture is distorted after selecting “Yes” in step 6, wait about 15 seconds. It will go back to Video-
Progressive menu automatically.
FunctionsetupUD.indd143FunctionsetupUD.indd143 2006/01/1116:30:142006/01/1116:30:14
To Next Page
Loading...
