e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FUSER / EXIT UNIT
13 - 14
[D] Exit sensor (S5)
(5) Remove 1 clip and 1 bushing.
(6) Take off the exit roller by sliding it to the rear
side.
Fig. 13-12
(1) Take off the fuser/paper exit unit.
P.13-12 "[A] Fuser / Exit unit"
(2) Release the stopper using a flathead screw-
driver.
Fig. 13-13
(3) Open the guide and slide it to the front side.
Then slide its rear hinge downward.
Note:
Keep the guide being slid to the front side
during the steps (3) and (4).
Fig. 13-14
Exit roller
Clip
Bushing
Stopper
Stopper
Guide
1
2
To Next Page
Loading...
