Setting up NetWare Print Server 21
24
Click [OK].
y When it finishes initializing, the Information dialog box appears.
25
Click [OK].
y The Configure Novell PDS for Printer Agent dialog box appears.
26
Select “((NONE))” in the “Printer Type” list and select “Novell Port
Handler” in the “Port Handler Type” list. Then click [OK].
y The Configure Port Handler for Printer Agent dialog box appears.
27
Continue the procedure according to which connection type to be
used.
P.21 “Configuring the LPR connection in the TCP/IP network”
P.21 “Configuring the queue based connection in the IPX/SPX network”
Configuring the LPR connection in the TCP/IP network
1
In the Configure Port Handler for Printer Agent dialog box, select
“Novell LPR Printer Gateway (SNMP)” (or “Remote (LPR on IP)”)
and click [Next].
2
Enter the IP address of this equipment in the “Host Address” field,
and click [Finish].
y It takes about 60 seconds to load the Printer Agent. After it finishes loading the
Printer Agent, the Select Printer Drivers dialog box appears.
3
Select the printer drivers to be installed in the “Printer Drivers” list
at each OS tab, and click [Continue].
y The Information dialog box appears.
4
Click [OK].
y It takes about 60 seconds to complete the creation of the NDPS Printer object.
5
Double-click the NDPS Printer object that you created.
y The NDPS Printer dialog box appears.
6
Click [NDPS Remote Printer Management].
7
Check the “Install to workstation in this container” and click
[Update].
8
Click [OK] to close the NDPS Printer dialog box.
Configuring the queue based connection in the IPX/SPX network
1
In the Configure Port Handler for Printer Agent dialog box, select
“Forward Jobs to a Queue” and click [Next].
To Next Page
Loading...
Need help?
General
