Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x 317
1) Password - Digit 1
Select the first digit of the Document ID.
2) Password - Digit 2
Select the second digit of the Document ID.
3) Password - Digit 3
Select the third digit of the Document ID.
4) Password - Digit 4
Select the forth digit of the Document ID.
5) Password - Digit 5
Select the fifth digit of the Document ID.
— Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1) Destination
This selects the destination tray.
- Auto — Select this to route the output to the default tray (that is set as the default tray for
raw job in the Printer setting page of TopAccess Administrator’s page).
- Inner Tray — Select this to route the output to the inner tray.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
y Depending on the type of finisher installed and destination settings, stapling and hole
punching may not be performed.
y Depending on the equipment settings, the paper may be delivered to a tray that cannot
carry out stapling or hole punching when “Auto” is selected as the “Destination” option.
y “Tray 1” and “Tray 2” can be selected when the Hanging Finisher, Finisher, or Saddle
Stitch Finisher are installed.
1
2
3
To Next Page
Loading...
