Printing from an Application 343
Output Bin
The output bin can be specified using the following options.
If the finisher option is not installed on the equipment, the default output tray will be used (inner).
If the finisher option is installed on the equipment, the default output tray will be used (bin2).
Example: The command to specify output bin 1 is “lp -o bin1 filename”.
Hole Punching
When the hole punch option is installed it can be activated using the following option.
If this option is not specified, the default value of “nopunch” will be used.
This function is not available for all paper sizes and the users should refer to the copier manual
for a list of compatible paper sizes. In particular, A5, A6 and statement paper sizes will not work
with this function.
Example: The command to hole punch the long edge feed portrait page is
“lp -o punch=1 filename”.
Media Type
The paper source can also be selected using the media type using the following option.
In PostScript Deferred Media Selection is always turned on so the paper size has priority over
the media type and the paper source.
In PCL5e the paper size always has priority over the media type and the paper source.
If this option is not specified, the default value will be used.
Example: The command to specify Thick1 media type is “lp -o mtype=Thick1 filename”.
Option Value
Alternate
Value
Description
inner Select the inner tray.
bin1 Select the upper output tray of the finisher.
bin2 Select the lower output tray of the finisher.
Option Value
Alternate
Value
Description
punch=0 nopunch Hole punching is turned off.
punch=1 Hole punch long edge without rotation.
punch=2 Hole punch short edge without rotation.
punch=3 Hole punch long edge with 180 degree rotation.
punch=4 Hole punch short edge with 180 degree rotation.
Option Value
Alternate
Value
Description
mtype=Plain The paper source that contains Plain paper is
requested.
mtype=
Transparency
The paper source that contains transparency slides is
requested.
mtype=Thick1 The paper source that contains Thick1 paper is
requested.
mtype=Thick2 The paper source that contains Thich2 paper is
requested.
mtype=Thick3 The paper source that contains Thich3 paper is
requested.
To Next Page
Loading...
